4-24 Epson TM-U950 Commands
Notes:
- When a paper sensor is enabled with this command, printing is stopped only when the
corresponding paper is selected for printing.
- It is possible to select multiple sensors for print control to stop printing. Then if any
sensor detects a paper end, the printer stops printing.
- When a paper end is detected, printing is stopped after printing the current line and
feeding the paper.
- When a paper end is detected by the journal or receipt sensor, the printer goes off-line
after printing stops.
- When the slip insertion sensor detects a paper end, the printer ejects the paper after
printing as much data as possible and enters the paper waiting state.
Default:
n = 12
ESC c 5 n
Enable/disable panel buttons
Hexadecimal code: 1B 63 35 n
Range:
n = 0-255
Enables or disables the panel buttons.
Notes:
-
When the LSB of n is 0, the panel buttons are enabled.
-
When the LSB of n is 1, the panel buttons are disabled.
- When the panel bottons are disabled, no buttons on the panel are usable. Therefore,
paper can be fed with the panel buttons only when the printer cover is open.
-
Only the lowest bit of n is valid.
Default:
n = 0
ESC d n
Print and feed
n
lines
Hexadecimal code: 1B 64 n
Range:
n = 0-255
Prints the data in the print buffer and feeds n lines.
Notes:
- This command sets the print starting position to the beginning of the line.
- The maximum paper feed amount is 40 inches. If the specified amount exceeds 40
inches, the paper feed amount is automatically set to 40 inches.
References:
ESC 2, ESC 3, ESC e
To Next Page
Loading...
