Olympus AL120-12 Series - Page 29

Operation Manual Outline of Operation Procedure
2-5
Page
4 Selecting the Type of Inspection Wafer: 4-way button
The initial menu appears on the liquid crystal panel .
1)
To change the type of inspection wafer shown on the liquid
crystal panel , press the [M2]  <Wafer> button to bring
the inspection wafer type selection screen.
2)
Press the 4-way button , and the <x> mark moves to the
number of the inspection wafer already registered.
Move <*> to the number of the type of wafer to be inspected,
and press the [M1]  <OK> button to determine the setting.
* Your loader may only have a setting for one type of wafer.
* Indication example when a setting for one type of wafer.
AL120-LMB12-LP3 ALL
Press Start button
No|size|Thick |comment
1.|300 |775-500 |
Recall Wafer Setting Memory
No |Size|Thick |Speed|comment
x1 | 300|775-500 |High |
2 | 300|775-500 |High |
3 | 300|775-500 |High |
4 | 300|775-500 |High |
5 | 300|775-500 |High |
6 | 300|775-500 |High |
OK Cancel PageUp PageDn
No |Size|Thick |Speed|comment
x1 | 300|775-500 |High |
OK Cancel PageUp PageDn
①
④
③
②