10
En
Getting started
Loading batteries
Use one CR-V3 lithium battery pack, or two AA (R6) NiMH batteries or
alkaline batteries.
• CR-V3 lithium battery packs cannot be re-charged.
• Do not peel the label on a CR-V3 lithium battery pack.
• Manganese (zinc-carbon) batteries cannot be used.
Important
1 Make sure that:
• The lens barrier is closed.
• The monitor is off.
• The lamps on the right of the viewfinder are off.
2 Slide the battery compartment cover in
the direction of
a (the direction
indicated by the mark on the cover),
and lift it up in the direction of
b.
3 Insert batteries in the direction shown in the illustration.
When using AA (R6) batteries
There is a mark on the bottom
of the camera showing the
correct way to insert batteries.
When using a CR-V3 lithium battery pack
a
b
4 Close the battery compartment cover so
that it pushes batteries down inside.
While pressing the mark, slide the
cover in the direction of
c.
• If the battery compartment cover seems hard to
close, do not force it. With the battery
compartment cover shut, press the mark
firmly and push in the direction shown in the
illustration.
c
1 D390/C150_B-E1 03.2.3 1:38 PM Page 10
To Next Page
Loading...
Need help?
General
