14
En
Getting started
Setting the date and time
1 Open the lens barrier fully.
2 Press .
• The top menu is displayed.
3 Press í on the arrow pad to select MODE MENU.
4 Press Ññ to select the SETUP tab, then press í.
5 Press Ññ to select , then press í.
• The green frame moves to the selected item.
6 Press Ññ to select one of the following date formats: Y-M-D
(Year/Month/Day), M-D-Y (Month/Day/Year), D-M-Y (Day/ Month/
Year). Then press
í.
• Move to the year setting.
• The following steps show the procedure used when the date and time settings are
set to Y-M-D.
7 Press Ññ to set the year, then press í to move to the month
setting.
• To move back to the previous setting, press É.
• The first two digits of the year are fixed.
8 Repeat this procedure until the date and time are completely set.
• The camera only displays the time in the 24-hour time system. (“2 pm” would be
“14:00”.)
9 Press .
• For a more accurate setting, press when the time hits 00 seconds. The
clock starts when you press the button.
10
Close the lens barrier to turn the camera off.
6 Press Ññ to select a language, then
press .
7 Press again to exit the menu.
8 Close the lens barrier to turn the camera off.
SELECT GO
ENGLISH
FRANCAIS
DEUTSCH
ESPAÑOL
1 D390/C150_B-E1 03.2.3 1:38 PM Page 14
To Next Page
Loading...
Need help?
General
