124
White Balance (Cont.)
Chapter 6
● We recommend using AUTO for normal shooting.
● When setting the white balance by pointing the camera at white paper, the
setting may be incorrect if the light reflected by the paper is too bright or
dark.
● White balance may not be effective under some special light sources.
● After setting the white balance, playback the image and check the color on
the monitor.
Setting limitations and Default settings (White balance)
The setting for the White balance differs depending on the shooting mode
concerned as shown below.
Mode dial
(Mode menu)
P
A/S/M/
Setting limitation
(–: Not available)
Factory default setting
Any of the 4 preset White
balances are available.
S-Prg
–
● No selection other than the default setting AUTO is available for the S-Prg
mode (the Night-scene mode has its own default setting). For the P and
A/S/M/ modes, the change in one shooting mode is forcibly applied to
other shooting modes.
AUTO
AUTO
Night-scene specific
setting
To Next Page
Loading...
Need help?
General
