183
Chapter 10
Transferring images to a computer
— Downloading (Cont.)
Windows 2000/Me
Make sure the camera’s access lamp is off, then do either of the following to
remove the USB cable:
(A) Click on the task bar.
1
Left-click on the “Unplug or Eject Hardware” icon (circled in the illustration
below) on the task bar (at the lower right-hand side of your computer
screen).
2
When a message appears saying that the driver has been stopped, left-
click on the message.
3
When a message appears saying that the hardware can be ejected safely,
click on the “OK” button.
4
Remove the USB cable.
(B) Double-click on the task bar.
1
Double-click on the “Unplug or Eject Hardware” icon (circled in the
illustration below) on the task bar (displayed at the bottom right on a
personal computer).
2
When the display for ejecting the hardware appears, select the camera
from the hardware device list, then click on the “Stop” button.
3
When a message appears saying that the hardware can be ejected safely,
click on the “OK” button.
4
Remove the USB cable.
To Next Page
Loading...
