85
Chapter 4
5
Press the shutter button all the way to
stop recording.
●
The card access lamp blinks and the
camera begins storing the movie on the
card. You cannot record another movie
while the card access lamp is blinking.
● When the card access lamp stops
blinking, the camera has finished writing
the movie to the card. If there is any
space left on the card, the number of
seconds remaining is displayed. You
can start recording another movie.
● If you use all the displayed seconds remaining, recording finishes
automatically without your pressing the shutter button, and the camera
starts writing the movie to the card.
If you take pictures continuously, the indication
changes as shown below.
Recording movies (Cont.)
● Shooting is not possible.
T Shooting is not possible while the camera is saving pictures to the
card. If the memory gauge goes off, you can take another shot.
T If CARD FULL appears, there is no space left on the SmartMedia card.
Delete pictures (P. 141, 142), replace with a new card (P. 29) or
transfer pictures to a computer (P. 172–184).
TIPS
Before
recording
After recording, these indications may still be on the
screen. Recording is not possible until they are gone.
Card access lamp
During recording
Recording
finishes
automatically.
To Next Page
Loading...
Need help?
General
