96
Chapter 4
Flash shooting (Cont.)
● The flash adjustment effect may not be sufficient if the shutter speed is too
fast.
Setting limitations and Default settings (Flash intensity control)
The setting for the Flash intensity control differs depending on the shooting
mode concerned as shown below.
Mode dial
(Mode menu)
P
A/S/M/
Setting limitation
(–: Not available)
Factory default setting
S-Prg
–
The Flash intensity control does not work in the Movie mode.
Adjustable throughout the
range of 2 to 2.
● No selection other than the default setting 0 is available for the S-Prg
mode. The P and A/S/M/ modes allow you to adjust throughout the
range of 2 to 2. However, change in one shooting mode is forcibly
applied to other shooting modes except for mode.
● For mode, the setting can be changed separately from other shooting
modes.
0
0
To Next Page
Loading...
