17
Getting started
1
1 Getting started
Attaching the strap
1 Pass the lens cap string through
the hole in the lens cap, then pass
the other end through the loop and
pull tight.
2 Pull the ends of the strap out of the
stopper and ring.
3 Thread one end of the strap (A)
through the string loop (attached to
the lens cap in step 1). Then thread
it through the strap eyelet on the
camera.
4 Thread the end of the strap back
through the ring and stopper as
indicated by the arrows. Adjust the
strap to the desired length.
5 Thread the end of the strap again
through the stopper as indicated by
the arrow. Pull the strap through the
stopper (B) to make sure it is
fastened securely.
6 Attach the strap to the other eyelet
following steps 3 to 5.
• Be careful with the strap when you carry the camera, as it can easily
catch on stray objects, causing injury or damage.
• Attach the strap correctly as shown above so that the camera does
not fall off. If the strap is attached incorrectly and the camera falls
off, Olympus is not responsible for any damages.
Stopper
Ring
A
Strap eyelet
B
Note
To Next Page
Loading...
Need help?
General
