52
3
Shooting basics
Recording movies
This function allows you to record movies. If R is set to ON, sound is recorded
at the same time.
1 Set the mode dial to n and press
the power switch.
g“Power on/off” (P.24)
• The monitor turns on.
• The available recording time on the card
that you are using is displayed.
2 Decide the composition of the
picture.
• You can use the zoom lever to enlarge
your subject.
3 Press the shutter button fully to
start recording.
• You can adjust the zoom during movie
recording.
• The card access lamp blinks while the
movie is stored on the card.
• During movie recording, N lights red.
4 Press the shutter button again to stop recording.
• When the remaining recording time has been used up, recording stops
automatically.
• When there is space in the card memory, the remaining recording time
(gP.97) is displayed, and the camera is ready to shoot.
Mode dial
Shutter button
Mode dial
Card access lamp
Power switch
00:36
00:36
00:10
00:10
Time remaining
To Next Page
Loading...
Need help?
General
