Olympus E-620 - Basic Operations

19
EN
Basic guide
Basic operations
There are three ways to operate this camera.
Using the direct buttons to operate the
camera
g P. 2 0
You can make the function settings with the control dial
and the direct buttons assigned to a function. Setting
information is displayed in the viewfinder and on the super
control panel while you are setting a function. This is
useful for operating the camera while composing the
subject in the viewfinder.
Descriptions in this manual
The operating instructions of the direct buttons, super control panel and menu are described as
follows in this manual.
• “ + ” indicates operations performed at the same time.
• “  ” indicates you should proceed to the next step.
e.g.: When setting the flash intensity control
Direct button # + Fj
Super control panel ip : [ w ]
Menu MENU  [ X ]  [ w ]
Resetting the camera
settings
In P , A , S , and M mode, current camera settings
(including any changes you have made) are
retained when the power is turned off. To reset the
camera to the factory default settings, set
[RESET] .
g “Resetting the camera settings” (P. 94)
j
Control dial
Setting on the menu g P. 2 2
You can use the menu to set shooting and playback
settings and customize camera functions.
Setting while looking at the super control
panel
g P. 2 1
You can make the function settings with the super control
panel on the LCD monitor. You can use the super control
panel to view the current settings and directly change the
settings.
Basic operations
E-620_MASTER.fm Seite 19 Dienstag, 17. Februar 2009 11:04 11