Exposure
2
43
EN
2
Exposure
The camera sets the optimum aperture value and shutter speed automatically according to
the subject brightness.
Set the mode dial to
P
.
•
When the shutter button is half-pressed, the shutter speed and
aperture value are displayed on the viewfinder. Releasing the shutter
button displays the shutter speed and aperture value on the super
control panel screen.
Program shift (
%
)
By turning the control dial in the P mode, you can change
the combination of aperture and shutter speed while
maintaining the optimum exposure.
g“Program line diagram (P mode)” (P. 134)
•
The program shift setting will not be cancelled after shooting.
To cancel program shift setting, turn the control dial until the
shooting mode indication
%
on the viewfinder or super control panel changes to
P
or turn off the
power.
•
Program shift is not available when you are using a flash.
The shutter speed and aperture value are blinking:
j
The optimum exposure cannot be obtained. For details, see “Exposure warning display”
(
g
P. 135).
Program shooting
TIPS
Super control panel
Aperture value
Shutter speed
Viewfinder
Shooting mode
AF confirmation mark
250 F5.6
2009. 03.16
AF
arge
Normal
OFF
E-620_MASTER.fm Seite 43 Dienstag, 17. Februar 2009 11:04 11
To Next Page
Loading...
