Olympus E-620 - Flash Bracketing

78
EN
5
Flash shooting
Setting display
x Notes
• This does not work during manual flash.
• This does not work when the flash control mode on the electronic flash is set to MANUAL.
• If flash intensity is adjusted on the electronic flash, it will be combined with the camera’s flash
intensity setting.
• When [w+F] is set to [ON], the flash intensity value will be added to the exposure
compensation value. g“w+F” (P. 102)
The camera shoots multiple frames, changing the amount of light emitted by the flash for
each shot. The camera shoots 3 frames at a time with the following amount of light: optimum
light, light adjusted in the – direction, and light adjusted in the + direction.
• The compensation value will change according to the EV step.
g “EV STEP” (P. 101)
• In single-frame shooting, the amount of light emitted by the
flash changes every time the shutter button is pressed.
• In sequential shooting, hold down the shutter button until the
selected number of frames are taken.
• Releasing the shutter button stops flash bracketing shooting.
When it stops,
0 blinks in the viewfinder and 0 is
displayed in green on the super control panel.
Direct button # + Fj
Super control panel ip : [ w ]
Menu MENU  [ X ]  [ w ]
Viewfinder
Flash bracketing
Menu MENU  [ X ]  [BRACKETING]  [FL BKT]
SETBACK
OFF
OFF
ON
RC MODE
0.0
MULTIPLE EXPOSURE
BRACKETING
8
00
0
+ 3
+ 2
+ 1
- 1
- 3
- 2
F button
j
# button
AE BKT
WB BKT
ISO BKT
FL BKT
BRACKETING
SETBACK
FL BKT
3F 0.7EV
3F 0.3EV
3F 1.0EV
OFF
E-620_MASTER.fm Seite 78 Dienstag, 17. Februar 2009 11:04 11