65
EN
Focusing and shooting functions
3
Focal lengths that can be set
•
If the focal length of the lens you are using is not listed, select the closest value.
x
Notes
• The image stabilizer cannot correct excessive camera shake or camera shake that occurs
when the shutter speed is set to the slowest speed. In these cases, it is recommended that
you use a tripod.
• When using a tripod, set [IMAGE STABILIZER] to [OFF].
• When using a lens with an image stabilization function, turn off the image stabilization
function of either the lens or the camera.
• If [IMAGE STABILIZER] is set to [I.S.1], [I.S.2] or [I.S.3] and you turn off the camera, the
camera will vibrate. This is due to the camera initializing the image stabilizer mechanism.
Without this initialization, the image stabilizer may not be able to achieve the proper effect.
• You may notice an operating sound or vibration when the image stabilizer is activated.
• If the image stabilizer icon blinks in red on the monitor, it indicates a failure of the image
stabilizer function. If you take a picture as is, the composition may be off. Consult your
Olympus Authorized Service Center.
• The image stabilizer will not activate at shutter speeds of over 2 seconds.
• If the internal temperature of the camera exceeds the specified temperature, the image
stabilizer is deactivated and the image stabilizer icon lights red on the monitor.
When set to
[OFF]
, you can turn off the beep sound that is emitted when the focus locks by
pressing the shutter button.
8mm 10mm 12mm 16mm 18mm 21mm 24mm 28mm 30mm 35mm
40 mm 48 mm 50 mm 55 mm 65 mm 70 mm 75 mm 80 mm 85 mm 90 mm
100 mm 105 mm 120 mm 135 mm 150 mm 180 mm 200 mm 210 mm 250 mm 300 mm
350 mm 400 mm 500 mm 600 mm 800 mm
1000 mm
Setting the beep sound
Menu
MENU
[
X
]
[
8
]
E-620_MASTER.fm Seite 65 Dienstag, 17. Februar 2009 11:04 11
To Next Page
Loading...
