109
Chapter 6 Measurement procedures (LX only)
2 Press the [MEAS/ENTER] joystick.
3 Insert an optical data media (USB memory) into the USB connector.
If the USB memory for recording images is inserted, the message shown below
is displayed. Remove the USB memory for recording images and insert an
optical data media.
Select “OK” and then press the [MEAS/ENTER] joystick. The new stereo optical
adapter’s name and set number are displayed.
4 Make sure that the adapter name and the set number for the new
stereo optical adapter are correct and then select “OK” and press
the [MEAS/ENTER] joystick.
To Next Page
Loading...
