114
Chapter 6 Measurement procedures (LX only)
Messages displayed during NEW STEREO ADAPTER
NOTE
• The messages of “STEP2A” will be displayed only if overwrite is required.
Step Description
- Execute NEW STEREO ADAPTER.
STEP1 Open the battery cover, insert an optical data media.
STEP2 Confirm the adapter name and set number.
STEP2A Overwrite the data that has already been registered.
STEP3 Tighten the adapter firmly in arrow direction.
Adapter unsteady or loose degrades measurement accuracy.
Do not use tools.
STEP4 After locating the small mark to the center, adjust for uniform brightness
with BRT button and push FREEZE button.
STEP5 Remove the optical data media.
To Next Page
Loading...
