Rec Monitor A n
Select whether or not to output audio while
recording from the earphone jack.
[On]:
Enables the recording monitor function. Sound
will be output from the EAR jack.
[Off]:
Disables this function. Sound will not be output
from the EAR jack.
N
ote
• W
hen the external speaker is connected while
recording, there is a risk that audio feedback
will occur. It is recommended that you use
earphones for the recording monitor, or turn
[Rec Monitor] to [Off] while recording.
Plug-inPower A n
External microphones which are supported by
plug in power can also be used. Whether or not
to supply power to external microphones can be
configured.
[On]:
When the plug-in power function is activated,
power will be supplied to the connected
external microphone. Select this when external
microphones supported by plug-in power are
connected (☞ P.40).
[Off]:
Disables this function. Select this when external
microphones not supported by plug-in power
are connected.
N
otes
• W
hen the [Input Jack] setting is set to [Line],
the plug in power function is disabled.
•
Turn the plug-in power function to [Off] when
an external microphone not supported by plug-
in power is connected, as there is the risk that
noise may be generated while recording.
•
Phantom power cannot be supplied, even when
the plug in power function is set to [On].
Input Jack A n
Select whether to use the recorder’s MIC jack to
connect an external microphone or as a LINE IN
jack to connect an external device.
[Microphone]:
Set this when connecting an external
microphone.
[Line]:
Set this when connecting an external device to
use the jack as a LINE IN.
N
ote
• W
hen the [Input Jack] setting is set to [Line],
the Low Cut Filter function is disabled (☞ P.66).
V-Sync. Rec A
See “Voice sync recording [V-Sync. Rec] A”
(☞
P.76).
Menu setting method
Menu setting method
To Next Page
Loading...
