Need help?Do you have a question about the Olympus PSD-30 and is the answer not in the manual?
General| Brand | Olympus |
|---|---|
| Model | PSD-30 |
| Category | Medical Equipment |
| Language | English |
Details the unit's intended use in endoscopic procedures and treatment applicability.
Explains manual usage, required operator qualifications, and instrument compatibility.
Covers repair policy, signal word definitions, and general hazards, warnings, and cautions.
Instructions for verifying all items are present and undamaged upon delivery.
Explains symbols used for warnings, outputs, and modes on the unit.
Identifies and describes all controls, indicators, and connectors on the front panel.
Details the connectors and features located on the rear panel of the unit.
Describes the function and components of the foot switch pedal used for output control.
Explains the S-cord used for connecting to the endoscope.
Details the P cord used for connecting the patient plate.
Specifies conditions for safely installing the electrosurgical unit on a stable surface.
Provides instructions for safely connecting the unit to a grounded power outlet.
Details how to properly connect the foot switch to the electrosurgical unit.
Guides on attaching the patient plate correctly to ensure safety and prevent burns.
Describes connecting the S-cord between the unit and endoscope for proper function.
Explains how to connect the A-cord to the endoscope accessory for electrosurgery.
Steps to verify the power supply is functioning correctly upon unit startup.
Procedure to test the foot switch for proper operation and responsiveness.
Verifies that alarm and warning indicators function correctly for safety.
Checks the selection and adjustment of cut modes and output power levels.
Verifies the selection and adjustment of coagulation modes and output power.
Confirms all accessories are connected before powering on the unit.
How to choose between PURE, BLEND1, and BLEND2 cut modes.
How to choose between SOFT, AUTO STOP, and FORCED coagulation modes.
Guidance on setting appropriate output levels for cut and coagulation modes.
Instructions for storing and recalling output settings and modes.
Key safety precautions and operational steps during electrosurgery.
How to activate stand-by mode to prevent accidental output during idle periods.
Steps to adjust the volume of output tones for user feedback.
Steps for safely disconnecting and preparing the unit after a procedure.
Instructions for cleaning the electrosurgical unit and its components safely.
Guidelines for proper storage to maintain unit integrity and prevent damage.
Information on following local laws and guidelines for unit disposal.
Table of possible causes and solutions for unit malfunctions and errors.
Details on various alarms (patient/S-cord, HF output, time, foot switch) and their triggers.
Procedure for contacting Olympus and preparing the unit for service or repair.
Illustrates the basic electrical and functional layout of the electrosurgical unit.
Recommended combinations of compatible equipment and accessories for the PSD-30.
Specifies ambient temperature, humidity, and air pressure requirements for operation.
Lists detailed technical data including output characteristics, voltage, and dimensions.
Details electromagnetic compatibility standards and guidance for safe usage.
To Next Page