Safety Accessories Supplementary Sheet
22 OMICRON
5 SAA2 Warning Lamp
5.1 Designated use
SAA2 Warning Lamp is a multifunctional Safety Accessory designed to increase the safety awareness and
safety while working with dangerous voltages or currents. It consists of a control unit and one or more signal
lamps which are fixed at or near the test object. Each signal lamp provides an Emergency Stop button to
switch off all outputs of the main device immediately and to bring the test setup into a safe state.
Furthermore, a green continous or a red continous/flashing light indicates the status of the main device.
Optionally, a buzzer inside signal lamps can generate an acoustig signal when an output of the main device
is active.
Figure 5: SAA2 Warning Lamp with its main components
Compatibility with main devices
SAA2 Warning Lamp is intended to be used together with the following main devices:
• CIBANO 500
• CPC 80 / CPC 100
• TESTRANO 600
• VOTANO 100
SAA2 control unit
Power supply
Signal lamp(s)
Connection cable
Power cable
SAA2 dongles
Safety interface cable
To Next Page
Loading...
Need help?
General