Omicron SAA1 User Manual

SAA2 Warning Lamp
23 OMICRON
See also the documents listed in the following table:
Table 10: Related documents to SAA2 Warning Lamp
Title Description
CIBANO 500 Getting Started
Contains safety information and use case examples for the
CIBANO 500 test system.
CIBANO 500 User Manual
Contains safety and operation instructions for the
CIBANO 500 test system.
COMPANO 100 Getting Started
Contains safety information and use case examples for the
COMPANO 100 test system.
COMPANO 100 User Manual
Contains safety and operation instructions for the
COMPANO 100 test system.
CPC Getting Started
Contains safety information and use case examples for the
CPC 80 and CPC 100 test systems.
CPC 80 User Manual
Contains safety and operation instructions for the
CPC 80 test system.
CPC 100 User Manual
Contains safety and operation instructions for the
CPC 100 test system.
CPC 100 Reference Manual
Contains detailed hardware and software information for the
CPC 100 test system including relevant safety instructions.
CPC 100 PTM User Manual
Contains information on how to use Primary Test Manager (PTM)
with CPC 100 test system.
TESTRANO 600 Getting Started
Contains safety information and use case examples for the
TESTRANO 600 test system.
TESTRANO 600 User Manual
Contains safety and operation instructions for the
TESTRANO 600 test system.
VOTANO 100 Getting Started
Contains safety information and use case examples for the
VOTANO 100 test system.
VOTANO 100 User Manual
Contains safety and operation instructions for the
VOTANO 100 test system.
5.2 Operation
WARNING
Death or severe injury caused by high voltage or current possible.
 Always test the SAA2 multifunctional Safety Accessory before putting it into
operation as described later in this chapter.
The SAA2 multifunctional Safety Accessory consists of a control unit and up to six signal lamps. The SAA2
control unit has its own power supply and the SAA2 control unit serves as a power supply for all connected
SAA2 signal lamps (see Figure 10 on page 26). Place the control unit near the main device and fix all signal
lamps close to the test object. The signal lamps must be well-visible for all relevant operators but be safe
from the impact of high voltages or currents.
The SAA2 system is active when the control unit is powered, the connection to the SAFETY output of the
main device is established and the main device’s Safety Connector Dongle is plugged into the

Omicron SAA1 Specifications

General

Brand	Omicron
Model	SAA1
Category	Safety Equipment
Language	English