• Set 1 to Alarm Reset Command (3002Hex-0FHex). (After a reset, this command automatically
returns to 0.)
• The state of bit 15 of Operation command (3002Hex-07Hex) is changed from 0 to 1, then returns
to 0. (It does not automatically return to 0.)
•
Be sure to confirm that the RUN command is turned OFF before resetting the alarm because the
machine may abruptly start depending on the setting of Start Check Function (3008Hex-61Hex).
6 Basic Settings
6-44
M1 Series EtherCAT Type User’s Manual (I670)
To Next Page
Loading...
