Omron CJ2 CPU UNIT - DIN Track Installation

5-15
5 Installation
CJ2 CPU Unit Hardware User’s Manual
5-2 Installation
5
5-2-5 DIN Track Installation
Use the following procedure to install a CJ-series PLC on DIN Track.
1 Release the pins on the backs of the CJ-series Units.
2 Fit the back of the PLC onto the DIN Track by inserting the top of the track and then pressing in
at the bottom of the PLC, as shown below.
3 Lock the pins on the backs of the CJ-series Units.
5-2-5 DIN Track Installation
Release
DIN Track
mounting pins
DIN Track
2
1
DIN Track
mounting pins