Omron CJ2 CPU UNIT - CX-Programmer

4-3
4 Support Software
CJ2 CPU Unit Hardware User’s Manual
4-1 Support Software
4
4-1-1 CX-One FA Integrated Tool Package
The CX-Programmer is a basic software application for creating and debugging PLC programs.
Application CX-One Software Description
Programming
CX-Programmer Basic software for creating and debugging PLC programs.
SwitchBox Utility Utility software to support PLC debugging operations.
Network settings
CX-Integrator
Software for starting and setting FA networks, such as Controller Link,
DeviceNet, CompoWay/F, Ethernet, and CompoNet. Includes routing table com-
ponents, data link components, and DeviceNet Configurator functions.
Network Configurator Software for setting tag data links for the built-in EtherNet/IP port.
CX-FLnet Software for making FL-net Unit system settings and performing monitoring.
Touch-panel screen
creation
CX-Designer Software for creating screen data for touch panel NS-series PTs.
NV-Designer Software for creating screen data for touch panel NV-series PTs.
Protocol macro cre-
ation
CX-Protocol
Software for creating protocols (protocol macros) for exchanging data with gen-
eral-purpose external devices connected to Serial Communications Boards/Units
and Option Boards.
Simulation CX-Simulator
Software for simulating PLC operations on a personal computer and debugging
programs without requiring a CPU Unit.
Motion Control
CX-Position Software for creating and monitoring data for Position Control Units.
CX-Motion-NCF
Software for creating and monitoring data for Position Control Units (MECHA-
TROLINK communications models).
CX-Motion-MCH
Software for creating data for Motion Control Units (MECHATROLINK communi-
cations models), and for creating and monitoring motion programs.
CX-Motion
Software for creating data for Motion Control Units, and for creating and monitor-
ing motion programs.
Servo/Inverter settings CX-Drive Software for setting and adjusting Inverter and servo data.
PLC-based process
control
CX-Process Tool
Software for creating and debugging function blocks for Loop Controllers (Loop
Control Units/Boards, Process CPU Units, and Loop CPU Units).
Face Plate Auto-Builder
for NS
Software for automatic generation of screen data (project files) for touch panel
NS-series PTs from Loop Controller function block tag information.
Temperature control
settings
CX-Thermo
Software for setting and adjusting Temperature Controller parameters.
CX-Programmer
Programming functions
CX-Programmer
I/O table creation
FBs ST language
ST language
SFC
language
PLC Setup
Debugging and
maintenance
functions
System configuration
setup
CPU Unit
parameters
Special I/O Unit and
CPU Bus Unit settings
Programming
Simulation
Monitoring
Tasks
Ladder
language
Ladder
language