Omron CJ2 CPU UNIT - Soldering; Assembling the Hood

A-135
Appendices
CJ2 CPU Unit Hardware User’s Manual
A-4 Connecting to a Serial Port on the CPU Unit
App
A-4-3 Applicable Connectors and Recommended Cables
4 Use wire strippers to remove the insulation from the end of each wire.
5 Wrap electrician's tape over the top and end of the cut sheath.
z Soldering
1 Place heat-shrinking tubes over all wires.
2 Pre-solder all wires and connector terminals.
3 Solder the wires.
4 Move the heat-shrinking tubes onto the soldered area and shrink them into place.
z Assembling the Hood
Assemble the connector hood as shown.
5 mm
Electrician's tape
1 mm
Heat-shrinking tube
(inner dia. 1.5, l = 10)
Soldering iron
Heat-shrinking tube
FG Connection
Ground plate
Aluminum foil tape
No FG Connection