Omron CJ2 CPU UNIT - A-8 Functions Supported for Unit Versions

A-155
Appendices
CJ2 CPU Unit Hardware User’s Manual
A-8 Functions Supported for Unit Versions
App
A-8-1 CJ2H CPU Units
A-8 Functions Supported for Unit
Versions
CX-Programmer version 9.1 or higher must be used to enable using the functions added for unit ver-
sion 1.3.
CX-Programmer version 8.3 or higher must be used to enable using the functions added for unit ver-
sion 1.2.
Note User programs that use functions of CJ2H CPU Units with unit version 1.2 or later cannot be used with CJ2H
CPU Units with unit version 1.1 or earlier. If an attempt is made to transfer a program that uses any of these
functions from the CX-Programmer to a CPU Unit with unit version 1.1 or earlier, an error will be displayed
and it will not be possible to download to the CPU Unit.
A-8-1 CJ2H CPU Units
Functions Supported for Unit Version 1.3 or Later
Units CJ2H CPU Units
Models CJ2H-CPU6@-EIP and CJ2H-CPU6@
Unit version
Function
Unit version
1.3 or later
Unit version
1.2
Unit version
1.1
Unit version
1.0
Special instructions
for certain Special I/O
Units
CJ1W-NC281/NC481/NC881
Position Control Units: PCU
HIGH-SPEED POSITIONING
(NCDMV(218))
Supported. Not supported. Not supported. Not supported.
CJ1W-NC281/NC481/NC881
Position Control Units: PCU
POSITIONING TRIGGER
(NCDTR(219))
Supported. Not supported. Not supported. Not supported.
New special instruc-
tions
SIGNED AREA RANGE COM-
PARE: ZCPS(088)
Supported. Not supported. Not supported. Not supported.
DOUBLE SIGNED AREA
RANGE COMPARE:
ZCPSL(116)
Supported. Not supported. Not supported. Not supported.
Unit Version 1.2 or Later
Unit CJ2H CPU Units
Model
CJ2H-CPU6@-EIP
CJ2H-CPU6
@
Unit version Unit version 1.2 or later Unit versions earlier than 1.2
EM Area Force-setting/resetting Supported. Not supported.