Omron CP1E - INTRODUCTION

A
Appendix
A-2 Instructions
SYSMAC CP1L/CP1E Introduction Manual 107
A-2 Instructions
CP-series has a rich instruction set. There are approximately 500 types of instructions that can be used
by CP1L and 200 types of instructions that can be used by CP1E. This section explains how to use the
instructions, and gives some basic instructions.
A-2-1 Using Instructions
With previous PLCs, from C-series to micro PLCs, instruction sets were designed
with the primary focus on handing BCD data. However, as data size grow and
exchange of data between computers becomes more commonplace, however,
support for BIN data has become a necessity for control equipment, as well.
In response to such needs and for greater convenience, many of the instructions for
handling BIN data have been added in the process of creating the CP-series.
Note For a list and explanation of the instructions, refer to the CX-Programmer Help.
For details on using the CX-Programmer Help, refer to 4-4 Using the Help.
■Notation for Instructions
●Instructions and Function Numbers
In this section, special instructions, which have a function number assigned are
displayed as a mnemonic followed by a 3-digit function number in parenthesis. E.g.
MOV(021).