Omron CP1E - INTRODUCTION - Section 5: Transferring and Debugging Programs; CP1 L Clock and Operating Mode Settings

SECTION 5
Transferring and Debugging
Programs
This section describes how to transfer and debug programs using
CP1L (14-point I/O unit with AC power supply) as an example.
To transfer data from a computer to CP1L, the computer and CP1L
must first be online.
Monitoring and debugging programs executed on CP1L are also
performed with the computer and CP1L online.
5-1 Going Online ......................................................................... 84
5-1-1 Setting the CP1L Clock .................................................. 85
5-1-2 Changing the Operating Mode ....................................... 86
5-1-3 Transferring Programs.................................................... 88
5-1-4 Executing Operations ..................................................... 90
5-2 Adjusting/Debugging Online ................................................. 91
5-2-1 Monitoring....................................................................... 91
5-2-2 Force-Setting/Force-Resetting ....................................... 94
5-2-3 Changing Timer Settings (Only CP1L) ........................... 95
5-2-4 Searching ....................................................................... 95
5-2-5 Online Editing ................................................................. 98
5-2-6 Confirming Cycle Time ................................................... 99