Omron CP1E - INTRODUCTION

3
SYSMAC CP1L/CP1E Introduction Manual 37
3-4 Power Testing CP1L
3
Mounting and Wiring
3-4 Power Testing CP1L
After wiring CP1L, perform a power test.
■Turning Power ON
Supply power to CP1L, and then check the status with the indicators.
1. Turn the power OFF for all components (escalation motor,
de-escalation motor, etc.).
2. Turn the power ON for CP1L.
3. Wait 2 seconds for the CP1L to initialize.
4. Check the indicators on CP1L. If [POWER] and [RUN] are lit, CP1L is
operating normally.
Note When CP1L is turned ON, it will go into RUN mode automatically.
5. Turn the power OFF for CP1L.
POWER
RUN
INH
PRPHL
BKUP
ERR/ALM