Omron CP1E - INTRODUCTION

4-4 Using the Help
4
4
52 SYSMAC CP1L/CP1E Introduction Manual
Creating Programs
●From CX-Programmer
1. Select [Help] - [Help Contents] from the main menu.
CX-Programmer Help will be displayed.
■Referencing PLC Instruction Sets
For details on instructions used in ladder programs, refer to PLC Instruction Sets.
●From CX-Programmer
1. Select [Help] - [Instruction Reference] - [CS/CJ-Series] from the main
menu.
CP-Series PLC Instruction Sets will be displayed.
●While Creating Ladder Programs
While creating an instruction in a ladder program in Smart Input Mode, press the
[F1] Key to display the Instruction Reference page for the instruction being edited.