Omron CP1E - INTRODUCTION

4-7 Editing Programs
4
4
SYSMAC CP1L/CP1E Introduction Manual 81
Creating Programs
• Creating a line from bottom to top:
Hold down the [Ctrl] key and press the up arrow key.
• Creating a line from top to bottom:
Hold down the [Ctrl] key and press the down arrow key.
Note Repeating the process over an existing connection line will delete it.
■Copying/Pasting Contacts/Instructions/Rungs
●Contacts/Instructions
1. Place the cursor on a contact or an instruction.
2. Hold down the [Ctrl] key and press the [C] key.
The selected contact or instruction will be copied to the clipboard.
3. Move the cursor to where you wish to paste. Hold down the [Ctrl] key and
press the [V] key.
The contact or instruction on the clipboard will be pasted.
●Rungs
1. Click the rung header of the rung you wish to copy.
The whole rung will be selected.
2. Hold down the [Ctrl] key and press the [C] key.
The selected rung will be copied to the clipboard.
3. Move the cursor to the rung where you wish to paste. Hold down the [Ctrl]
key and press the [V] key.
The rung on the clipboard will be pasted.