Omron CX-DESIGNER - INTRODUCTION GUIDE - Reuse of Screen (by Copying)

23-4 Reuse of screen (by copying)
23-4 Reuse of screen (by copying)
“Reuse of Screen” is a function to use an already-made screen and copy them to
another project.
In this manual, you will reuse Screen Page 1 made in the sample project (GUIDE) to
another project (GUIDE 2).
Right-click [0000:
Screen Page 1] on the
Project Workspace to
display the pull-down
menu.
Click [Copy].
Start-up another CX-
Designer and create a
project “GUIDE 2” by
referring to“3. New Project”.
Do not close the CX-
Designer on which you
have been editing the
project “GUIDE”.
Right-click [Screen
Page] to display the
pull-down menu.
Click [Paste].
Enter [Paste from No.].
(“0” is set in this manual.)
Click
Start up
CX-D
Creating a
new project
Project
property
System
setting
Creating
a screen
Validation
Transferring
a project