Omron CX-DESIGNER - INTRODUCTION GUIDE - Repeat Function

11.Repeat function
11.Repeat function
Using a [Repeat] function to copy a object already created.
In this manual, you will copy an ON/OFF button with [Repeat] function.
Right-click the created
button.
Select [Repeat(R)] from
the pop-up menu.
Set as follow:
[Qty]
Horizontal ![1]
Vertical ! [5]
[Spacing]
Horizontal ! [0]
Vertical ! [0]
Select a repeat direction.
Set 1 to [Offset Address].
11-1 Repeat function
(Button)
11-1 Repeat function
(Button)
Start up
CX-D
Creating a
new project
Project
property
System
setting
Creating
a screen
Validation
Transferring
a project