5 Communications settings
5 Communications settings
Making communications settings for the NS hardware to connect with the PLC.
In this manual, you will connect the NS to the PLC thru Serial port A.
Double-click
[Comm. Setting].
Click
Click
[System] in the Project
Workspace.
Click [Serial Port A]
Set as follow:
Serial Port
![PLC]
Host Name
![HOST1]
Protocol
![NT Link(1:N)]
Comm. Speed
![High-speed]
[Comm.-All], [Ethernet],
[Controller Link] settings
are not required.
You can make communication
settings when creating a new project.
Click [Comm. Setting] in the New
Project dialog box as described in 3
“Creating a new project”.
Start up
CX-D
Creating a
new project
Project
property
System
setting
Creating
a screen
Validation
Transferring
a project
<Note>
To Next Page
Loading...
