Omron CX-DESIGNER - INTRODUCTION GUIDE - Transfer using Memory Card

2. Transferring project dada using a memory card
2. Transferring project dada using a memory card
Before you start…
Install the memory card to the personal computer.
Click
Click
Click
Change the settings to
the “Direct data transfer
to NS/Computer” on the
Comm. Method dialog.
[Comms. Method]
! “Memory Card”
[Drive]
! “H”
*Select the drive to
which the memory card
is installed.
[Bank]
! “Bank 1”
*There are four banks
available for memory
cards. One project is
downloaded to a bank.
Here, you specify the
bank to be transferred.
Start up
CX-D
Creating a
new project
Project
property
System
setting
Creating
a screen
Validation
Transferring
a project