Transferring project data
Transferring project data
Transferring projects created on CX-Designer to the NS hardware.
There are six ways to transfer a project: serial cable, Modem, Ethernet,
Controller link, USB and Memory card.
In this manual, you will transfers project data via serial cable and using a memory card.
1. Transferring project data via serial cable(RS232C)
1. Transferring project data via serial cable(RS232C)
Click
Select “Serial” from the
Comms. Method pull-
down menu.
Before you start…
Connect the NS hardware to the personal computer with the communication cable
(XW2Z-S002).
Click the Setting button.
Click the Set… button.
Start up
CX-D
Creating a
new project
Project
property
System
setting
Creating
a screen
Validation
Transferring
a project
To Next Page
Loading...
