EasyManua.ls Logo

Omron DEVICENET - Shielded T-Branch Connectors

Omron DEVICENET
163 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
57
Cables, Connectors, and Related Devices Section 2-3
DCN1-3C T-branch Tap Components
DCN1-2C and DCN1-2R T-branch Tap Components
2-3-5 Shielded T-branch Connectors
Use a T-branch Connector when a T-branch is required in a Network that has
communications cables with shielded connectors.
Note 1. If the T-branch Connector is at the end of the trunk line, the trunk line can
be terminated by connecting a shielded connector with Terminating Resis-
tance. (Male plug and female socket terminators are available.)
2. When the Network is powered by a single communications power supply
and the current consumption is within the T-branch Connectors specifica-
tions, the communications power supply can be connected to a T-branch
DCN1-3C
T-PORT TAP
Mounting screw holes
Use when screwing the T-
branch Tap to a control
panel.
Terminating Resistor socket
Connect a Terminating
Resistor here if the T-branch
Tap is installed at the end of
the trunk line.
Communications Connectors
Connect the network communications cables to the provided XW4B-
05C1-H1-D Straight Connectors.
Communications Connectors
Connect the network communications cables to the provided
XW4B-05C1-H1-D Straight Connectors.
DIN Track mounting hooks
Use when mounting the Tap to a DIN Track.
DCN1-4
T-PORT TAP
Mounting screw holes
Use when screwing the T-
branch Tap to a control
panel.
Terminating Resistor socket
Connect a Terminating
Resistor here if the T-branch
Tap is installed at the end of
the trunk line.
Communications Connectors
Connect the network communications cables. The following connectors are provided.
DCN1-4C: XW4B-05C1-H1-D Straight Connector with attachment screws
DCN1-4R: XW4B-05C1-VIR-D Right-angle Connector with attachment screws
Communications Connectors
Connect the network communications cables. The following connectors are
provided.
DCN1-4C: XW4B-05C1-H1-D Straight Connector with attachment screws
DCN1-4R: XW4B-05C1-VIR-D Right-angle Connector with attachment screws
DIN Track mounting hooks
Use when mounting the Tap to a DIN Track.

Table of Contents

Related product manuals