184
Operation Level Section 5-3
This parameter starts and stops the simple program function.
• The RUN/STOP status will automatically switch to RUN when this param-
eter is set to STRT.
• The simple program will stop when this parameter is set to RSET.
• This parameter will function as a monitor display for the start/stop status
of the simple program if an event input is selected to start the simple pro-
gram.
â– Related Parameters
Soak time remain: Page 184, RUN/STOP: Page 185 (operation level)
Bank * soak time, Wait band (bank setting level): Page 215
Program pattern (initial setting level): Page 229
Soak time unit (advanced function setting level): Page 266
• This parameter measures and displays the remaining time of the soak
time for the simple program function.
â– Related Parameters
Program start (operation level): Page 184
Bank * soak time, Wait band (bank setting level): Page 215
Program pattern (initial setting level): Page 229
Soak time unit (advanced function setting level): Page 266
prst Program Start
The Program Pattern parameter
must not be set to OFF.
Setting range Default
RSET Stops the simpler program. rset
STRT Starts the simpler program.
Function
Operation
See
See
sktr Soak Time Remain
The Program Pattern parameter
must not be set to OFF.
Monitor range Unit
0 to 9999 min or h
Function
Monitor
See
See
To Next Page
Loading...
Need help?
General
