Omron E5AN-H

215
Bank Setting Level Section 5-5
These parameters set the soak time for each bank.
• These parameters set the time for the control operation in each bank
when using the simple program function
• When the bank function is enabled, this parameter is enabled when the
current bank program pattern is not set to OFF.
■ Related Parameters
Program start, Soak time remain (operation level): Page 184
Bank (*) wait band (bank setting level): Page 215
Program pattern (initial setting level): Page 229
Soak time unit (advanced function setting level): Page 266
These parameters set the wait band for each bank.
• These parameters set the stable band, in each bank, within which the
soak time is measured for the simple program function.
• When the bank function is enabled, this parameter is enabled when the
current bank program pattern is not set to OFF.
■ Related Parameters
Program start, Soak time remain (operation level): Page 184
Bank (*) soak time (bank setting level): Page 215
Program pattern (initial setting level): Page 229
Soak time unit (advanced function setting level): Page 266
*.sok Bank Soak Time
The Program Pattern parameter
must not be set to OFF.
Setting range Unit Default
0 to 9999 min or h 1
Function
Settin
g
See
See
*.wtb Bank Wait Band
The Program Pattern parameter
must not be set to OFF.
Setting range Unit Default
Temperature: OFF,
0.1 to 3,240.0
°C or °F off
Analog: OFF, 0.01 to
99.99
%FS
Function
Settin
g
See
See