229
Initial Setting Level Section 5-9
• Auto-tuning can be started during self-tuning.
â– Related Parameters
Input type: Page 224, PID ON/OFF: Page 228 (initial setting level), ST stable
range (advanced function setting level): Page 247
This parameter sets the type of control when using the simple program func-
tion.
• If the Program Pattern parameter is set to OFF, the simple program will
not operate.
• If the Program Pattern parameter is set to STOP, the RUN/STOP status
will change to STOP after execution has been completed up to the bank
number specified in the Valid Program Bank parameter.
• If the Program Pattern parameter is set to CONT, control will continue in
RUN status after execution has been completed up to the bank number
specified in the Valid Program Bank parameter.
• If the Program Pattern parameter is set to LOOP, the program will return
to bank number 0 and repeat the program operation.
â– Related Parameters
Program start, Soak time remain: Page 184, RUN/STOP: Page 185 (operation
level)
Bank * soak time, Bank * wait band (bank setting level): Page 215
Soak time unit (advanced function setting level): Page 266
Parameter name Setting range Unit Default
ST off: ST function OFF, on: ST
function ON
None on
Setting
See
See
ptrn Program Pattern
Setting range Default
off Simple program function turned OFF off
stop Go to STOP mode at end of program.
cont Continue in RUN mode at end of program.
loop Return to bank number 0 and repeat the program
operation.
Function
Setting
See
See
To Next Page
Loading...
Need help?
General
