Omron E5AN-H User Manual

211
Bank Setting Level Section 5-5
■ Related Parameters
PID (*) proportional band, PID (*) integral time, PID (*) derivative time (PID
setting level): Page 217
PID (*) automatic selection range upper limit (PID setting level): Page 218
PID set automatic selection data (advanced function setting level): Page 269
These parameters are used to set the SP ramp set value for each bank.
• The SP ramp set value can be set for banks 0 to 7.
• This parameter specifies the rate of change during SP ramp operation.
Set the maximum allowable change width per unit of time as the SP ramp
set value. When this parameter set to OFF, the SP ramp function will be
disabled.
• During temperature input, the decimal point position for the SP ramp set
value depends on the current sensor, and during analog input it depends
on scaling.
■ Related Parameters
Input type: Page 224
Scaling upper limit, Scaling lower limit, Decimal point: Page 226
ST (initial setting level): Page 228
SP ramp time unit (advanced function setting level): Page 244
These parameters set one of the input values "X" in the alarm type list for
each bank.
• These parameters set the value for alarm value 1 in banks 0 to 7.
• During temperature input, the decimal point position is set automatically
according to the current sensor, and during analog input it depends on the
Decimal Point parameter setting.
See
See
*.spr Bank 0 to 7 SP Ramp Set Value
The ST parameter must be set to
OFF.
Setting range Unit Default
OFF, 1 to 32400 EU/s, EU/min, EU/h OFF
Function
Settin
g
See
See
*.a-1
Bank * Alarm Value 1
(*: 0 to 7)
Alarm 1 must be assigned.The
alarm 1 type must not be 0, 1, 4, 5,
or 12.
Setting range Unit Default
−19999 to 32400 EU 0.0
Function
Settin
g

Omron E5AN-H Specifications

General

Brand	Omron
Model	E5AN-H
Category	Temperature Controller
Language	English