Omron FQ2-S Series User Manual

Command Control
FQ2-S/CH User’s Manual
for Communications Settings
205
5
Appendices
File Load Commands
*: Commands that are used for the no protocol (TCP) communications only.
Batch sets the ON/OFF status for the all parallel I/O out-
put terminals other than the D terminals (D0 to D15).
NA OK OK OK OK OK
Batch sets the ON/OFF status for the D terminals (D0 to
D15).
NA OK OK OK OK OK
Sets the FQ2 execution status (execution mode). NA OK OK OK OK OK
OK: Applicable command, RST: Command with restricted execution, NA: Non-applicable command
Function Parallel
p. 46, p. 75
PLC link
p. 135
EtherNet/
IP
p. 112
PROFINET
p. 159
No-proto-
col (TCP/
UDP/RS-
232C)
p. 180, p. 185
No-proto-
col (FINS)
p. 193
Loads scene data that is stored on the SD card inserted
in the Touch Finder.
NA OK OK OK OK OK
Loads all scene data that is stored on the SD card
inserted in the Touch Finder.
NA OK OK OK OK OK
Loads system data that is stored on the SD card
inserted in the Touch Finder.
NA OK OK OK OK OK
Loads all setting data (all scene data, system data, cali-
bration group data) for the Sensor saved as a backup
file from the SD card inserted in the Touch Finder.
NA OK OK OK OK OK
Loads calibration data that is stored on the SD card
inserted in the Touch Finder as the specified calibration
number.
NA OK OK OK OK OK
Loads all calibration data that is stored on the SD card
inserted in the Touch Finder.
NA OK OK OK OK OK
Loads model dictionary data that is stored on the SD
card inserted in the Touch Finder as the model dictio-
nary with the specified number.
NA OK OK OK OK OK
Loads all model dictionary data that is stored on the SD
card inserted in the Touch Finder.
NA OK OK OK OK OK
Loads scene data in binary data format. NA NA NA NA OK
*
NA
Loads all scene data in binary data format. NANANANAOK
*
NA
Loads system data in binary data format. NANANANAOK
*
NA
Loads all setting data for the Sensor in binary data for-
mat.
NA NA NA NA OK
*
NA
Loads calibration data in binary data format. NA NA NA NA OK
*
NA
Loads all calibration data in binary data format. NANANANAOK
*
NA
Loads model dictionary data in binary data format. NA NA NA NA OK
*
NA
Loads all model dictionary data in binary data format. NA NA NA NA OK
*
NA
OK: Applicable command, RST: Command with restricted execution, NA: Non-applicable command
Function Parallel
p. 46, p. 75
PLC link
p. 134
EtherNet/
IP
p. 112
PROFINET
p. 159
No-proto-
col (TCP/
UDP/RS-
232C)
p. 179
No-proto-
col (FINS)
p. 193
FQ2-S_CH_comm.book 205 ページ ２０１４年６月２６日 木曜日 午前１１時４７分

Omron FQ2-S Series Specifications

General

Brand	Omron
Model	FQ2-S Series
Category	Security Camera
Language	English