NOTICE
Observe proper electrostatic discharge procedures (ESD) when handling the drive and circuit boards.
Failure to comply may result in ESD damage to the drive circuitry.
Never connect or disconnect the motor from the drive while the drive is outputting voltage.
Improper equipment sequencing could result in damage to the drive.
Do not perform a withstand voltage test on any part of the drive.
Failure to comply could result in damage to the sensitive devices within the drive.
Do not operate damaged equipment.
Failure to comply could result in further damage to the equipment.
Do not connect or operate any equipment with visible damage or missing parts.
Install adequate branch circuit short circuit protection per applicable codes.
Failure to comply could result in damage to the drive.
The drive is suitable for circuits capable of delivering not more than 30,000 RMS symmetrical Amperes, 240 Vac
maximum (200 V Class) and 480 Vac maximum (400 V Class).
Do not expose the drive to halogen group disinfectants.
Failure to comply may cause damage to the electrical components in the drive.
Do not pack the drive in wooden materials that have been fumigated or sterilized.
Do not sterilize the entire package after the product is packed.
u
Drive Label Warnings
Always heed the warning information listed in Figure i.1 in the position shown in Figure i.2.
Risk of electric shock.
WARNING
Read manual before installing.
Wait 1 minute for capacitor discharge after
disconnecting power suppl
y.
To conform to requirements, make sure
to ground the supply neutral for 400V class.
Figure i.1 Warning Information
Figure i.2 Warning Information Position
u
Warranty Information
n
Restrictions
The
J1000 was not designed or manufactured for use in devices or systems that may directly affect or threaten human lives
or health.
i.2 General Safety
SIEP C710606 33A OYMC AC Drive – J1000 User Manual
13
To Next Page
Loading...
Need help?
General