Start-Up Programming & Operation
This chapter explains the functions of the LED operator and how to program the drive for initial
operation.
4.1 SECTION SAFETY............................................................................................52
4.2 USING THE DIGITAL LED OPERATOR..........................................................54
4.3 THE DRIVE AND PROGRAMMING MODES....................................................57
4.4 START-UP FLOWCHART.................................................................................62
4.5 POWERING UP THE DRIVE.............................................................................63
4.6 NO-LOAD OPERATION TEST RUN.................................................................64
4.7 TEST RUN WITH LOAD CONNECTED............................................................65
4.8 VERIFYING AND BACKING UP PARAMETER SETTINGS............................66
4.9 TEST RUN CHECKLIST...................................................................................67
4
SIEP C710606 33A OYMC AC Drive – J1000 User Manual
51
To Next Page
Loading...
