Omron NE1A Series - Page 108

109
Outline of Programming Section 6-1
■ Input Tags
Input tags reflect the status of inputs in the following I/O areas.
• Input area from the NE1A-series Controllerís local terminals
• Input area from safety slaves registered as communications partners
• I/O area reflected from Safety Master data
• I/O area reflected from Standard Master data
Input tags used in the Logic Editor include the following information.
In Controllers with unit version 1.0 or later, data are reflected in the following
I/O areas.
• Local input status
• Local output status
• General Unit status
• Test output status
• Muting lamp status
■ Output Tags
Output tags reflect the status of inputs in the following I/O areas.
• Output area from the NE1A-series Controllerís local terminals
• Output area from safety slaves registered as communications partners
• I/O area reflected from Safety Master data
• I/O area reflected from Standard Master data
Output tags used in the Logic Editor include the following information.
Node address
Registered I/O comment
Bit address
Attribute (“[S]” for safety I/O)
Attribute (“[S]” for safety I/O)
Node address
Registered I/O comment
Bit address