Omron NE1A Series - Logic Function: Comparator

126
Command Reference: Logic Functions Section 6-4
6-4-7 Logic Function: Comparator
Diagram
Default Connections
General Description
This function can be used only in NE1A-series Controllers with unit version
1.0 or later.
The Comparator compares the specified input signals (up to 8 inputs) with the
comparison value set in the configuration, and turns ON the Output 1 signal
when all of the input signals match the comparison value.
The Output 1 signal will be turned OFF when the input signals no longer
match the comparison value.
From 1 to 8 inputs can be set for the input signals.
Set Parameters
Optional Input Settings
The number of inputs can be increased on the In/Out Setting Tab Page in the
function block property dialog box.
Maximum Number of Inputs for the Comparator Logic Function
Input1
Output1
Parameter Setting range Default setting
Comparison Value 00000000 to 11111111 (bit 0 to bit 7) 00000001
Parameter Setting range Default setting
Number of inputs 1 to 8 1
Output1
Input1
Input2
Input3
Input4
Input5
Input6
Input7
Input8