Omron NE1A Series - Function Block: ON-Delay Timer

149
Command Reference: Function Blocks Section 6-5
Timing Chart
6-5-8 Function Block: ON-delay Timer
Diagram
General Description
The ON-delay Timer function block performs a timer operation for an ON
delay set in 10-ms increments. The range for this delay is from 0 ms to 300 s.
Set Parameters
The ON-delay time must be equal to or greater than the NE1A-series Control-
ler’s cycle time.
Timing Chart
Input
Output
Enable
Set Value
Timer Value
0
Idle to RUN
Parameter Setting range Default setting
ON-delay Time 0 to 300 s in 10-ms increments 0 ms
Input
Output
Enable
Set value
T imer value
0
Idle to RUN