Omron NE1A Series - Functions Supported in each Operating Mode

184
NE1A-series Controller Operating Modes Section 8-1
8-1-3 Functions Supported in Each Operating Mode
The following table shows the conditions in each NE1A-series Controller
mode and operations supported from the Network Configurator in each mode.
Note (1) A password could be required for operations from the Network Configu-
rator.
For details, refer to Section 7 Other Functions.
(2) When the operating mode of the NE1A-series Controller is changed from
RUN to IDLE, input data to the Master depends on the hold setting of the
Standard I/O Area. For details, refer to Section 4 DeviceNet Communica-
tions Functions.
(3) Depends on the configuration lock setting. For details, refer to Section 7
Other Functions.
(4) Depends on reset types and the configuration lock setting. For details, re-
fer to Section 7 Other Functions.
Operating
mode
Safety functions Standard
functions
Operations from Network Configurator z
(See note 1.)
User program
Safety I/O communications
Local I/O control
(including test outputs)
Standard I/O
communications
Message communications
Configuration
Configuration lock/
unlock
Reset
Changing password
Online monitor
RUN Sup-
ported
Supported Refreshed Sup-
ported
Sup-
ported
Supported
(See note
3.)
Supported Sup-
ported
(See
note
4.)
Sup-
ported
Supported
IDLE Stopp
ed
Stopped Safety State Sup-
ported
(See
note
2.)
Sup-
ported
Supported
(See note
3.)
Supported Sup-
ported
(See
note
4.)
Sup-
ported
Supported
CONFIG-
URING
Stopp
ed
Stopped Safety State Stopp
ed
Sup-
ported
Supported Not
supported
Sup-
ported
Sup-
ported
Supported
ABORT Stopp
ed
Stopped Safety State Stopp
ed
Sup-
ported
Not
supported
Not
supported
Sup-
ported
(See
note
4.)
Sup-
ported
Supported
CRITICAL
ERROR
Stopp
ed
Stopped Safety State Stopp
ed
Stopped Not
supported
Not
supported
Not
sup-
ported
Not
sup-
ported
Not
supported
INITIALIZA-
TION
Stopp
ed
Stopped Safety State Stopp
ed
Stopped Not
supported
Not
supported
Not
sup-
ported
Not
sup-
ported
Not
supported