Omron NE1A Series - Function Block: OFF-Delay Timer

148
Command Reference: Function Blocks Section 6-5
Timing Chart
6-5-7 Function Block: OFF-delay Timer
Diagram
General Description
The OFF-delay Timer function block performs a timer operation for an OFF
delay set in 10-ms increments. The range for this delay is from 0 ms to 300 s.
Set Parameters
The OFF-delay time must be equal to or greater than the NE1A-series Con-
troller’s cycle time.
Idle to RUN 500 ms 500 ms 500 msDiscrepancy
Time
Input1
(Pair1-NO)
Output
Enable
Discrepancy
Error Pair1
Input2
(Pair1-NC)
Input3
(Pair2-NO)
Fault
Present
Input4
(Pair2-NC)
Discrepancy
Error Pair2
Parameter Setting range Default setting
OFF-delay Time 0 to 300 s in 10-ms increments 0 ms