175
Command Reference: Function Blocks Section 6-5
Decrementing counter:
6-5-16 Logic Function: Multi Connector
Diagram
Default Connections
General Description
This function can be used only in NE1A-series Controllers with unit version
1.0 or later.
The Multi Connector function outputs input signals (up to 8 inputs) to output
signals (up to 8 outputs).
The input signals and output signals are associated one-to-one from number
1 to 8. The status of other input signals has no effect.
Idle to RUN
Input 1
Set value
Count
Output 1
Input 2
Idle to RUN
Input 1
Set value
Count
Output 1
Input 2
Output1
Input1
To Next Page
Loading...
