Omron NE1A Series - Page 12

13
System Configuration Section 1-2
NE1A Standalone System
If there are only a few I/O points, the NE1A-series Controller can be used as
Standalone Controller.
The Controller’s DeviceNet communications can be disabled through settings
made from the Network Configurator to enable the NE1A-series Controller to
operate as Standalone Controller.
IMPORTANT Use a USB port connection to set Standalone Mode. DeviceNet communica-
tions are stopped when Standalone Mode is set, and so setting is not possible
from the DeviceNet port.
Emergency stop
buttons
Door switches
Two-hand switche
s
Network Configurator
USB communications
Contactors
NE1A
(Standalone)